
This article may contain affiliate links. If you buy through them, guitar.care may earn a small commission at no extra cost to you.
Are Those Fine Lines in Your Guitar's Finish Checking?
Finish checking is a network of hairline cracks in the lacquer only, not the wood. It is almost always cosmetic. Your fingernail will not catch on it, and the lines form a web rather than one clean split. It comes from the finish and the wood moving at different rates, and it is permanent once it appears.
The short answer
- What it is
- Cracks in the finish layer only
- Fingernail test
- Glides over it, no catch
- Pattern
- Fine web or scattered short lines
- Usually affects
- Nitrocellulose lacquer
- Cure
- None; prevention and acceptance
- Repair worth it?
- Rarely, for playing guitars
What Checking Looks Like
Checking appears as short, thin lines, often running in several directions, so the surface looks like crazed glaze on old pottery. You see it most on the body top, back, and sides, and along the neck and headstock. It looks worst under raking light, where a flashlight held low and to the side picks out every line.
Look for these features:
- Lines are shallow and fine, with no visible gap between the edges.
- Many lines sit close together, rather than one long line.
- The wood underneath looks the same color on both sides of the line.
- Nothing has changed shape: no raised bridge, no sunken top, no step across a line.
If that matches, you are almost certainly looking at checking. If one line is long, catches a nail, or sits near a seam, brace, bridge, or headstock joint, skip ahead to the section on telling the two apart.
Why Lacquer Checks
Nitrocellulose is a thin, hard film. Wood swells and shrinks with temperature and moisture, and the film does not move in step with it. When the stress gets large enough or arrives fast enough, the film cracks rather than flexing. Over years, nitro also becomes more brittle, so older guitars check more readily than new ones.
Our guide to guitar finish types explains how to tell nitro from polyurethane. Polyurethane and polyester finishes are generally tougher and check far less often, so a guitar with a modern thick gloss coat is unlikely to show it.
Temperature Shock Is the Sharp Trigger
Humidity drift matters, but a fast temperature change is the harder blow. A guitar that goes from a cold car into a warm room, or from a warm room onto a cold porch, has its surface change while the wood below lags behind. That mismatch is what splits the film. The practical rule is to let a guitar adjust slowly in its closed case, which our cold-weather transport guide covers step by step. Heat does the same job from the other side, as the hot car damage checklist explains.
Slow Humidity Swings Add Stress
A guitar that swings between a dry heated winter and a damp summer flexes its wood every year. That adds up on a brittle finish. Keeping the room stable helps, and our humidity guide sets out the 45-55% RH band to aim for. A cheap hygrometer in the room or case tells you whether you are inside it.
Top pick
Digital Hygrometer
Seeing a dangerous swing coming is the only real defence against checking, since nothing reverses it afterward.
Checking vs. a Real Crack
The distinction matters because one is a cosmetic note and the other can be urgent. Run through these checks in order.
The Fingernail Test
Draw a fingernail lightly across the line. Checking is shallow, so the nail passes smoothly. A crack through the wood usually catches, and you may see a thin gap or darker wood inside it.
The Pattern Test
Checking spreads as many fine lines or a web. A structural crack tends to be a single line that follows the grain of the top, runs along a seam, or radiates from a stress point such as the bridge, the soundhole edge, or the neck joint.
The Movement Test
Press gently either side of the line. A finish crack does not move. If edges shift, buzz, or the line has visibly grown over weeks, treat it as a wood problem. Our crack triage guide walks through which cracks are urgent and which can wait.
If you cannot decide, photograph it under raking light, mark the end of the line in the photo, and compare a month later. A line that has not grown is a good sign. A line that has lengthened should go to a luthier.
Does Checking Hurt the Guitar?
On its own, no. The lines do not affect tone or playability, because the finish is thin and adds little stiffness to the top. Two things are worth watching.
First, deep checking can let moisture or dirt reach bare wood. Wiping the guitar down with a clean cloth after playing keeps grime out of the lines, and a soft microfiber cloth will not snag on them.
Second, aggressive polishing can push product into the lines, where it dries white and highlights them. Use a polish labelled safe for nitro, use it sparingly, and leave out silicone-heavy products.
Recommended gear
Guitar Polish (Finish-Safe)
Choose one labelled safe on nitrocellulose, and use a small amount so it does not collect in the lines.
Can You Repair Checking?
There is no way to close the cracks, because the film has already failed there. What exists is a set of choices, and most of them cost more than they return.
Leave It
For most players this is the right answer. A guitar with checking plays and sounds as it did before, and many players like how it looks as the guitar ages.
Have It Touched Up or Refinished
A refinish removes the old lacquer and sprays new, which makes the guitar look fresh but also removes the original finish. On a collectible instrument that can cut value well below what the checking did, and the new finish is not immune to checking either. For a player-grade guitar you love, a refinish is a cosmetic choice, not a repair. Ask a luthier what they would do on your specific instrument, and get a quote before agreeing.
Think Before You Sell
If you plan to sell, describe the checking honestly in the listing, with a photo. Buyers expect some on older nitro, and our selling prep guide covers how to describe wear so there are no surprises. If you are buying, our used guitar checklist helps separate checking from damage you should walk away from.
How to Prevent More Checking
Prevention is the only lever you actually have.
- Acclimate slowly. After a cold or hot journey, leave the guitar in its closed case until the case feels room temperature.
- Avoid extremes. Keep it away from vents, windows, radiators, and car trunks.
- Hold humidity steady. Aim for the 45-55% RH band all year, not just in winter.
- Store it well. A good case buffers sudden swings; our storage guide explains the trade-offs against stands.
- Check your pad materials. Some stand rubber softens nitro too, which is a separate problem covered in our stand and finish damage post.
Recommended gear
Hardshell Guitar Case
A closed hardshell case slows temperature change around the guitar, which is the main defence against new checking.
Treat Checking as a Warning, Not a Defect
Checking tells you the guitar has seen a temperature or humidity swing. The existing lines are cosmetic and stay put. Use them as a prompt to slow down your acclimation habits and stabilise the room, and the finish will stop collecting new ones. If you want deeper routines for protecting a nitro guitar year-round, the care guides go further.